Citrix states in their article: CTX304357

CTX304357 - How to Install Citrix MetaFrame and Windows NT Terminal Server on an IBM Netfinity 5600 Server

This document was published at: http://support.citrix.com/kb/entry.jspa?externalID=CTX304357

Document ID: CTX304357, Created on: May 31, 2000, Updated: Apr 23, 2003

Products: Citrix MetaFrame 1.8 for Microsoft NT 4.0 Server Terminal Server Edition

This application note describes how to install Citrix MetaFrame and Microsoft Windows NT 4.0, Terminal Server Edition, on an IBM Netfinity 5600 Server.

Software Requirements

• Microsoft Windows NT 4.0, "Terminal Server Edition, Version 4.0 or later

• MetaFrame Version 1.x

• IBM ServeRAID Device Drivers, Version 3.10 (or higher)

• IBM Netfinity 10/100 Fault Tolerant Adapter Device Drivers, Version 1.01 (or higher)

Before Installation

1. Obtain the required device drivers by contacting IBM Support or visiting their Web site at http://www.pc.ibm.com/support?page=brand&brand=IBM +PC+ServerŹCNetfinity+5000.

2. Create Windows Terminal Server boot disks. From the console of a Windows NT 4.0 workstation or server, start a DOS prompt and type winnt32 /ox from the \I386 directory on the Windows Terminal Server CD-ROM and follow the on-screen instructions.

Installing Terminal Server and MetaFrame

1. Insert Terminal Server Edition boot disk #1, turn on the machine, and follow the on-screen instructions.

2. When prompted to autodetect mass storage controllers, press S to skip mass storage detection.

3. Press S to configure additional SCSI adapters.

4. Expand the list of additional SCSI adapters, select Other (located at the end of the list), and press ENTER.

5. When prompted for a driver diskette, insert the IBM ServeRAID Device Drivers diskette and press ENTER. Select the IBM ServeRAID Adapter and press ENTER to continue.

6. Press S to configure additional SCSI adapters. Expand the list of additional SCSI adapters, select the select IDE CD-ROM (ATAPI 1.2) / Dual-channel PCI IDE controller, and press ENTER to continue.

7. See the Microsoft Windows Terminal Server Installation Guide to continue the installation.

8. From the Network Adapters dialog box, click Select from list to display the Select Network Adapter dialog box.

9. Click Have Disk and insert the IBM Netfinity 10/100 Fault Tolerant Device Drivers diskette. Click OK to continue.

10. Select the AMD PCNET adapter and click OK to continue.

11. See the Microsoft Windows Terminal Server Installation Guide to complete the installation.

12. Insert the MetaFrame Version 1.x CD-ROM and choose MetaFrame Setup from the list of on screen options.

• See the MetaFrame Administrators Guide to complete installation and setup.